email:  password:

Authoring Tools

[reply] [back to forum] [new message] [all forums]

Subject: Chisel ...too strict? Sender: Matt Keveney 23.05.04 02:17 All, ...not sure where I should ask this; If I'm in the wrong place, please advise. I've been playing around with Chisel/Vorlon & have a few questions: 1) Does anyone out there know of a central place for support of this tool? Or a CVS system for maintaining the source? (I have a contribution). 2) One of my files names a Material node (via DEF) for later use in other nodes. Works fine in Cortona. Chisel complains with "Error, invalid child node" ..even though it's at the top level of the file; not a child of any group node. As I read the spec, this should be OK. Can anyone give me an interpretation that would agree with Chisel/Vorlon's error message? -Matt   [reply] [back to forum] [new message] [all forums] Chisel ...too strict? / Matt Keveney / 23.05.04 02:17      Re: Chisel ...too strict? / degor aka Installation Guru / 29.11.04 05:40 Messages in thread: 2 [reply] [back to forum] [new message] [all forums]